9W GU10 COB Review

General Information

ID #243
Series N/A
Manufacturer Intech Power Solutions (other LEDs from Intech Power Solutions)
Fitting Type GU10 (other GU10 LEDs)
Light Type Downlight (PAR)
Height 85mm
Diameter PAR16 (50mm)
Weight 106g
Warranty N/A
Test Date 2014-01-30
Review Notes Carries C-Tick approval label. Dimming performance was fair on a Clipsal 32E450UDM universal dimmer (results provided below). Dimming on a HPM CAT250L leading edge dimmer generated noticeable flicker especially at low light levels (see flicker on a leading edge dimmer in gallery). Ebay seller only offers 7 day warranty (but claims a 35 years lifetime). Seller claims manufacturer is Intech Power Solutions, but globe is not listed on IPS site.
Price $28 (AUD) from EBay seller modsorrockers on 29th of January 2014


LED Specifications

Claimed Measured Compared To
Watts 9W 7.7W @ 242V 50.2W @ 242V
Yearly Running Cost[?] $1.97 $1.69 $10.99
Lumens 550 lm 504 lm 498 lm
Efficiency[?] 61 lm/W 65 lm/W 10 lm/W
Lumens/Purchase Price 20 lm/$ 18 lm/$ 144 lm/$
Power Factor[?] N/A 0.83 1
Color [?] Warm White, 3000K Warm White, 2965K Warm White, 2737K
Angle[?] 60° 45° 33°
Dimmable Yes, Leading or Trailing Edge Fair Yes, Leading or Trailing Edge
CRI (Color Accuracy)[?] 82 81
Life 50,000 hours Not Measured 2,000 hours
Min/Max Voltage 90V / 240V 220V / 240V
Min/Max Temperature N/A / 65°C N/A
Measured Temperature 67°C @ 25°C ambient
153°F @ 77°F ambient
192°C @ 25°C ambient
378°F @ 77°F ambient
Flicker Percent[?] 76% 9%
Flicker Index[?] 0.141 0.029


Link to manufacturer specifications at time of testing


Dimming measurements

Graph notes: Dimming performance can be highly dependant on the type of dimmer, the number of lights in the circuit and other factors. Results in your house might vary. Mouse over the graph for more details. Position 10 = Not dimmed. Position 1 = Fully dimmed.



Distribution Graph

Angle: 45° (±22.5° from bottom), Maximum lux:

Graph notes: Shows the intensity of the light when viewed from different angles. Normal omni-directional globes have a fairly constant output all the way around (excepting directly above). Downlights have a narrow range at the bottom in which the light is emmited, this determines their angle.


Spectrum Graph

Representation of color spectrum

Graph notes: Shows the breakdown of the LED light into its component colors. With short wavelength ultraviolet on the left and long wavelength infrared on the right. The green line represents the relative absolute strength of the light at each frequency, while the red line represents what the typical human eye would see. The human eye is most sensitive to green light, but much less sensitive to purples and deep reds.


Flicker Graph

Graph of measured flicker

Percent: 76%, Index: 0.141 (lower is better in both cases)

Graph notes: Shows variation in light output over 1/10th of a second, with relative light output on the Y axis and time on the X Axis. Measured with a photodiode connected to an Oscilloscope. Ideally the yellow line should be flat. Low frequency high amplitude waveforms mean there is a possibility of noticeable flicker, but sensitivity to flicker varies between people. [More details about LED flicker]


Disclaimer: While every effort has been made to ensure the accuracy of these results, each measurement carries an inherent degree of uncertainty and error. Safety and EMC compliance of products to regional or international standards have not been verified unless noted as an ENERGY STAR® LED Lighting Facts, or SSL Quality Scheme certified product. Retailers and importers selling unmarked or unapproved electrical goods can be fined or imprisoned. Mains supplied downlights require installation by a licensed electrician.